A rocking chair project...
...ripped fabric, broken down seat, and loose joints
I was surprised to find only one webbing strip on the back.
Lots of difficult nails to pull!
The webbing was shot, and the padding worn down.
Hammered loose joint apart, and re-glued.
Also had to fix a bolted side piece.
Some light sanding and a few coats of walnut Restor-a-Finish
Now it's time to rebuild the seat and back.
Love my staple gun system!
(Porter-Cable US58 1/4-Inch to 5/8-Inch 22-Gauge C-Crown Upholstery Stapler and DEWALT 6 Gal. 165 PSI Electric Pancake Air Compressor )
(Porter-Cable US58 1/4-Inch to 5/8-Inch 22-Gauge C-Crown Upholstery Stapler and DEWALT 6 Gal. 165 PSI Electric Pancake Air Compressor )
Finished on Sunday, April 22, 2018
No comments:
Post a Comment